Home / Automatic Doors / ChickenGuard Door Opens or Closes at the Wrong Times? Check These 7 Things
ChickenGuard Door Opens or Closes at the Wrong Times? Check These 7 Things
A ChickenGuard that moves reliably but at the wrong time usually has a clock, timer or light-sensor problem. The correct fix depends on whether you use Timer mode or Sensor mode.
Quick answer
Timer users should verify the current clock, AM/PM or 24-hour value and the programmed open and close times. Sensor users should take a LUX reading and confirm it rises in daylight and falls in darkness. Reversed readings can require changing Light Sense Type back to LDR.
1. Confirm you are not in Manual mode
Check both Open Settings and Close Settings before troubleshooting timing.
2. Timer users: verify the clock
A 12-hour AM/PM mistake can shift operation to the opposite half of the day. Also check whether a power loss reset the clock to 00:00.
3. Check the programmed open and close times
Make sure each timer is in the valid range for your ChickenGuard model.
4. Sensor users: take a live LUX reading
Daylight should produce a higher value than darkness. A reading stuck at 0 or moving backwards indicates a sensor configuration problem.
5. Check Light Sense Type
ChickenGuard says most units use LDR. If the controller is set to Photo Diode incorrectly, light readings can behave backwards.
6. Tune the LUX thresholds
If the door opens too early, raise the open threshold. If it opens too late, lower it. For closing, lower the close value to close later and raise it to close earlier, staying within the manufacturer’s recommended range.
7. Check motor direction if opening and closing are reversed
If the screen says Opening while the door closes, use our reversed-direction guide.
Why a door can close immediately after opening
ChickenGuard notes that a door that is too heavy, a bad sensor reading or an incorrect timer clock can cause this behavior.
Frequently asked questions
Why is my ChickenGuard opening at night?
Start with the clock and open-mode setting, then verify sensor readings if you use light mode.
Can power loss change the clock?
Yes. A reset clock can make otherwise correct timer values operate at the wrong real-world time.
Sources checked
We checked ChickenGuard’s current wrong-time troubleshooting article and light-sensor guidance.